Free Worldwide Delivery On Orders Over £150

Rifle Magazine Carriers Available Here

Silva Compass Carrier Overview

Every Silva Compass Carrier will include x4 Male mounting screws, x4 Female Mounting Screws, x4 Rubber Mounting Spacers and either X2 Malice Clips for Molle mounting or X1 DCL Combat Loop for Belt mounting.

To remove or adjust the mount included with the carrier, simply open the mount, place one finger inside the carrier on the back of one of the female mounting screws and with a Phillips head screwdriver undo the male screw on the outside face of the carrier. If you are unable to apply enough pressure to the back of the female mounting screw inside the carrier, try putting a wide rubber band between your finger and the female mounting screw you’re trying to undo.

Each carrier has x2 5mm rivets securing the front and back of the carrier together at the bottom. These rivets can also be used to thread a piece of Paracord through to allow the user to wear the carrier as a lanyard or to tie the carrier to their belt loop if the are not wearing a belt.

 

  • Made from 2mm P1 Kydex T Thermoplastic

  • Wrapped in IR Compliant Genuine 500D Cordura (where applicable)

  • All screws included will have threadlock pre-applied to stop them from backing out or coming loose over time

 

 

If during use, you have any issues with the function of the Compass Carrier, do not hesitate to contact us through the form on this website or email us at Sales@kydexcustomsuk.com

 

Silva Compass Carrier Overview

Every Silva Compass Carrier will include x4 Male mounting screws, x4 Female Mounting Screws, x4 Rubber Mounting Spacers and either X2 Malice Clips for Molle mounting or X1 DCL Combat Loop for Belt mounting.

To remove or adjust the mount included with the carrier, simply open the mount, place one finger inside the carrier on the back of one of the female mounting screws and with a Phillips head screwdriver undo the male screw on the outside face of the carrier. If you are unable to apply enough pressure to the back of the female mounting screw inside the carrier, try putting a wide rubber band between your finger and the female mounting screw you’re trying to undo.

Each carrier has x2 5mm rivets securing the front and back of the carrier together at the bottom. These rivets can also be used to thread a piece of Paracord through to allow the user to wear the carrier as a lanyard or to tie the carrier to their belt loop if the are not wearing a belt.

 

  • Made from 2mm P1 Kydex T Thermoplastic

  • Wrapped in IR Compliant Genuine 500D Cordura (where applicable)

  • All screws included will have threadlock pre-applied to stop them from backing out or coming loose over time

 

 

If during use, you have any issues with the function of the Compass Carrier, do not hesitate to contact us through the form on this website or email us at Sales@kydexcustomsuk.com